Recommended use:
As a shop- and or transportprimer on steel that still needs a lot of welding. Solely applicable on blasted steel.

Main characteristics:
Very suitable for processing with spray equipment.Till 30 micron dry film thickness, excellent weldable without harmful vapours. Dependent on applied film thickness and curingtime it is suitable as a prefab primer in practical all paint systems. Manageable after 5 minutes on steel with a temperature of 40 °C. Time of protection of ca. three months is strongly dependent on the applied film thickness.

Surface preparation:
New steel: abrasive blasting to Sa 2.5, with a surfaceroughness of approximately 50µm. The substrate should be completely dry and free from oil, grease or other contaminations.

In case of repair: all kinds of damages should be blasted with a fine and dry blastingmaterial. When blasting is not possible, the substrate should be cleaned with a powertool.

In case of maintenance: the substrate should be made free of grease. This can be done by means of high-pressure spraying pistol and tapwater with optional cleansing agent. Also steamcleaning can be used. After cleaning rinse and dry the substrate properly. All damaged and loose paint should be removed by means of blasting. If it is not possible to blast, the substrate can be cleaned with a powertool.

Recoating:
The substrate should be clean and dry. In case of recoating a just applicated film of paint, it is sufficient to remove dust and sand before recoating. In case of recoating old or damaged layers of paint, treat the substrate as mentioned in the section surface preparation.