Recommended use:
As a anti-corrosive primer on shot blast steel surfaces and steel that has been thoroughly cleaned of rust. Use in a “KPC-AK” paint system. It can also be used as a topcoat on a properly primed substrate.

Main characteristics:
Easy to process by brush or air spray. Excellent anti-corrosive properties. Very good adhesion on grit blast steel or steel that has been thoroughly cleaned of rust. Easy to apply in high film thickness.

Surface preparation:
New steel: abrasive blasting to Sa 2.5, with a surfaceroughness of approximately 50µm. The substrate should be completely dry and free from oil, grease or other contaminations.
Note: when scraping and wire-brushing on old red leads, precautions should be taken against poisoning.

In case of repair: all kinds of damages should be blasted with reduced pressure. When blasting is not possible, the substrate should be cleaned with a powertool.

In case of maintenance: the substrate should be made free of grease. This can be done by means of high-pressure spraying pistol and tapwater with optional cleansing agent. Also steamcleaning can be used. After cleaning rinse and dry the substrate properly. All damaged and loose paint should be removed by means of blasting. If it is not possible to blast, the substrate can be cleaned with a powertool.